
DPF Cleaning in Riga – Filter & Catalytic Converter
Complete diesel particulate filter restoration in Riga – hydrodynamic washing, forced regeneration without removal, results verified with CSDD-grade emissions equipment
Price: from €80 incl. VAT
Check availability for your vehicle
Enter plate number or select your car manually

Why you need DPF cleaning
Cleaning costs 85% less than replacement
A new DPF filter runs 1,500 to 4,000 euros. Professional hydrodynamic washing restores factory-level flow capacity at a fraction of that cost. Regular DPF maintenance extends both filter and engine lifespan.
Full-cycle wash, not a blow-through
We use a King CAR DPF Washing Machine with specialized chemistry that dissolves soot and ash without damaging the ceramic substrate. This is controlled hydrodynamic processing – not compressed air or pressure washer force.
Restore lost power and fuel economy
A clogged DPF creates exhaust backpressure that chokes the engine, increasing fuel consumption by 10-30% and cutting power output. After cleaning, the engine runs at nominal capacity again – no strain, no excess fuel burn.
Forced regeneration without removal
For moderate soot buildup, we offer forced DPF regeneration through diagnostic equipment. Software-triggered regeneration burns accumulated soot at 600-700 C directly on the vehicle – no dismounting required.
Results verified by emissions testing
Before and after cleaning, we measure particulate levels on Capelec CAP and smoke opacity on TEXA OPABOX – the same equipment used at official vehicle inspections (CSDD). You see the improvement in hard numbers.

DPF cleaning process
Diagnostic assessment
We connect Launch X431, read fault codes, measure DPF differential pressure and soot contamination level. Endoscopic inspection reveals the internal condition of the filter and catalytic converter.
Pre-cleaning emissions measurement
Capelec CAP records particulate count; TEXA OPABOX captures smoke opacity coefficient. These baseline readings serve as the reference point for verifying results.
Removal and hydrodynamic washing
We carefully remove the DPF or catalytic converter and place it in the King CAR DPF Washing Machine. Specialized chemistry dissolves soot and ash deposits across all ceramic channels – no mechanical scrubbing, no structural damage.
Drying, gasket replacement, reinstallation
After washing – thorough drying. We reinstall the filter with fresh gaskets and clamps, then verify every connection for airtight seal integrity.
Post-cleaning measurement and test drive
Repeat emissions test on Capelec and TEXA – compare directly against pre-cleaning readings. Fault codes cleared, test drive completed, final diagnostics run. We confirm the filter performs like new.
What you get
Filter flow capacity restored
exhaust backpressure returned to factory specification
Engine power recovered
no more strain, limp mode, or throttle restrictions
Fuel consumption reduced
root cause of up to 30% excess consumption eliminated
Results confirmed by particulate measurement – vehicle inspection-ready
Filter lifespan extended
costly replacement avoided
Our equipment
King CAR DPF Washing Machine
Professional hydrodynamic cleaning unit for diesel particulate filters and catalytic converters. Delivers specialized chemistry at controlled pressure, dissolving soot and ash without ceramic damage.
Specialized cleaning chemistry
Professional-grade solution engineered for deep DPF and catalytic converter cleaning. Dissolves ash and soot deposits while remaining neutral to ceramic structure and catalytic coating.
Launch X431
Diagnostic platform for reading fault codes, measuring DPF differential pressure, initiating forced regeneration, and running post-cleaning verification checks.
Capelec CAP / TEXA OPABOX
Vehicle inspection-grade emissions analyzers for particulate count and smoke opacity measurement. Capelec measures solid particles (post-2013 diesels), TEXA OPABOX reads smoke opacity (k-value). Used before and after cleaning for objective result verification.

Sound familiar?
DPF warning light or Check Engine indicator illuminated on dashboard
Engine lost power – sluggish acceleration, no pulling force under load
Fuel consumption increased noticeably without any change in driving habits
Excessive exhaust smoke – black or grey plumes, burning smell from tailpipe
Vehicle inspection approaching, and DPF hasn't been cleaned in over 100,000 km
Vehicle entered limp mode – power or RPM restricted by engine management

FAQ
DPF cleaning at JVK PRO in Riga costs from €80 including VAT. Flush without removal – from €80, off-car wash – from €120. The exact price depends on the make, engine and scope of work – we confirm it before starting, by plate number or after diagnostics. Pay-later with KLIX is available.
Hydrodynamic washing restores filter flow capacity at roughly 85% less than the cost of a new DPF. Replacement is justified only when the ceramic core is physically damaged – cracked, melted, or collapsed. In every other scenario, professional cleaning delivers the same result for a fraction of the price.
Every 100,000 km as preventive maintenance. City driving with frequent short trips clogs the filter faster because on-road regeneration cycles never complete. If symptoms appear – power loss, higher fuel consumption, visible smoke – clean it immediately.
Yes. We offer forced DPF regeneration via Launch X431 – software-triggered combustion burns soot at 600-700 C without dismounting the filter. This works for moderate contamination. If the filter is heavily blocked or ash has accumulated, full hydrodynamic washing with removal is necessary.
Backpressure rises, the engine works under constant overload, and fuel consumption increases 10-30%. In advanced cases – limp mode activation, power restriction, turbo overheating. Repairing the collateral damage costs many times more than cleaning the filter.
Absolutely. The King CAR DPF Washing Machine operates at controlled pressure with chemistry formulated to be neutral to ceramic. This is not mechanical scrubbing or pressure-washer force – the ceramic honeycomb and catalytic coating remain fully intact.
With quality cleaning and normal driving conditions – another 80,000 to 100,000 km before the next service. Longevity depends on fuel system health, injector condition, and driving patterns. We verify the result with Capelec and TEXA emissions measurement before handover.
Restore your DPF – skip the costly replacement
Professional DPF and catalytic converter cleaning in Riga with results verified on CSDD-grade emissions equipment – 85% more affordable than a new filter
+371 22 11 11 16Book DPF Cleaning
Pay later
Don't want to pay now? Purchase online – pay later!
Go to payment