Jeep Wrangler 2.8 CRD 200hp
Stage 1 chip tuning
Diesel turbo · 2010 - 2016 · Bosch EDC17C69 · VM11D / ENS
Stage 1 Results
* Values are approximate. Contact us for a precise calculation.
Technical Information
About the remap
Stage 1 chip tuning for the Jeep Wrangler 2.8 CRD 200hp increases power from 200 to 236 hp (+36 hp, +18%) and torque from 410 to 520 Nm. Turbocharged diesel engines offer the greatest chip tuning potential – optimizing boost pressure and injection maps delivers significant gains in both power and torque from low RPM.
The remap is performed on the Bosch EDC17C69 ECU (engine code VM11D / ENS) via the OBD2 diagnostic port – no ECU removal required. We use Alientech KESSv2, Autotuner Autotuner, ByteShooter Toolbox and other professional tools. Results are verified with a dynamometer measurement.
Under normal driving conditions, chip tuning a turbocharged diesel can reduce fuel consumption – in Eco mode, savings reach up to 1 l/100 km thanks to more efficient turbo operation and optimized injection.
In addition to Stage 1, we offer the following services for the Jeep Wrangler 2.8 CRD 200hp: DPF diagnostics and maintenance, EGR valve diagnostics. All work is performed using professional equipment (Siemens/Continental EGS53 gearbox).
If desired, the Jeep Wrangler 2.8 CRD 200hp can be upgraded to Stage 2 – a deeper optimization delivering even greater power and torque gains. Stage 2 involves advanced ECU calibration taking into account exhaust system and intercooler modifications. Contact us for a free consultation to evaluate Stage 2 potential for your specific vehicle.
Every vehicle undergoes full diagnostics before and after the remap. We keep a backup of the original ECU calibration and guarantee the option to revert to stock settings at any time. JVK PRO is a professional chip tuning service in Riga with 16 years of experience.
Available services
FAQ
How much does Stage 1 chip tuning cost in Riga?+
Stage 1 chip tuning at JVK PRO in Riga costs from €200 including VAT; with dyno tuning and measurements – from €350. We confirm the exact price for your engine before starting.
Is Stage 1 safe for the engine?+
Yes. Stage 1 is an optimization within factory safety margins. The remap is done via the OBD2 diagnostic port without opening the ECU. Results are verified on our dynamometer.
How long does it take?+
Usually 2 to 4 hours, including diagnostics, remapping, and a dyno verification run.
Can the original software be restored?+
Yes, we keep a backup of your original ECU file. Reverting to stock is possible at any time.
Book Stage 1
Leave a request – we will contact you
By clicking, you agree to the processing of personal data