BMW 5 serie M550I 462hp

Stage 1 chip tuning

Petrol turbo · G30/31 - 2016 - 2019 · Bosch MG1CS003 · N63B44O2

Stage 1 Results

Stock (hp)

462

Stage 1 (hp)

542

Gain (hp)

+80 (17%)

Torque

650 → 780 Nm +130

* Values are approximate. Contact us for a precise calculation.

Technical Information

Fuel typePetrol turbo

Tuning levelStage 1

MethodOBD2

Engine codeN63B44O2

ECUBosch MG1CS003

GearboxZF 8HP

GenerationG30/31 - 2016 - 2019

Reading tools

Autotuner AutotunerCMD CMDFlashDimsport New GeniusMagicMotorsport FlexPCM-Flash PCM-Flash

About the remap

Stage 1 chip tuning for the BMW 5 serie M550I 462hp increases power from 462 to 542 hp (+80 hp, +17%) and torque from 650 to 780 Nm. Turbocharged petrol engines respond exceptionally well to ECU optimization – adjusting ignition timing, boost pressure, and fueling maps unlocks the hidden potential built in by the manufacturer.

The remap is performed on the Bosch MG1CS003 ECU (engine code N63B44O2) via the OBD2 diagnostic port – no ECU removal required. We use Autotuner Autotuner, CMD CMDFlash, Dimsport New Genius and other professional tools. Results are verified with a dynamometer measurement.

In addition to Stage 1, we offer the following services for the BMW 5 serie M550I 462hp: XHP gearbox tuning. All work is performed using professional equipment (ZF 8HP gearbox).

Every vehicle undergoes full diagnostics before and after the remap. We keep a backup of the original ECU calibration and guarantee the option to revert to stock settings at any time. JVK PRO is a professional chip tuning service in Riga with 16 years of experience.

Available services

Airbag Diagnostics Intake Cleaning Mileage Check Return to Stock Stage 1 XHP Tuning

FAQ

How much does Stage 1 chip tuning cost in Riga?+

Stage 1 chip tuning at JVK PRO in Riga costs from €200 including VAT; with dyno tuning and measurements – from €350. We confirm the exact price for your engine before starting.

Is Stage 1 safe for the engine?+

Yes. Stage 1 is an optimization within factory safety margins. The remap is done via the OBD2 diagnostic port without opening the ECU. Results are verified on our dynamometer.

How long does it take?+

Usually 2 to 4 hours, including diagnostics, remapping, and a dyno verification run.

Can the original software be restored?+

Yes, we keep a backup of your original ECU file. Reverting to stock is possible at any time.