Ford Ranger 2.5 TD 110hp
Stage 1 chip tuning
Diesel turbo · -> 2010 · Mitsubishi E6T0xx · WL-T
Stage 1 Results
* Values are approximate. Contact us for a precise calculation.
Technical Information
About the remap
Stage 1 chip tuning for the Ford Ranger 2.5 TD 110hp increases power from 110 to 143 hp (+33 hp, +30%) and torque from 266 to 303 Nm. Turbocharged diesel engines offer the greatest chip tuning potential – optimizing boost pressure and injection maps delivers significant gains in both power and torque from low RPM.
The remap is performed on the Mitsubishi E6T0xx ECU (engine code WL-T) using the Bench/Boot method with direct ECU connection. We use ByteShooter Toolbox. Results are verified with a dynamometer measurement.
Under normal driving conditions, chip tuning a turbocharged diesel can reduce fuel consumption – in Eco mode, savings reach up to 0.9 l/100 km thanks to more efficient turbo operation and optimized injection.
In addition to Stage 1, we offer the following services for the Ford Ranger 2.5 TD 110hp: DPF diagnostics and maintenance, EGR valve diagnostics. All work is performed using professional equipment.
If desired, the Ford Ranger 2.5 TD 110hp can be upgraded to Stage 2 – a deeper optimization delivering even greater power and torque gains. Stage 2 involves advanced ECU calibration taking into account exhaust system and intercooler modifications. Contact us for a free consultation to evaluate Stage 2 potential for your specific vehicle.
Every vehicle undergoes full diagnostics before and after the remap. We keep a backup of the original ECU calibration and guarantee the option to revert to stock settings at any time. JVK PRO is a professional chip tuning service in Riga with 16 years of experience.
Available services
FAQ
How much does Stage 1 chip tuning cost in Riga?+
Stage 1 chip tuning at JVK PRO in Riga costs from €200 including VAT; with dyno tuning and measurements – from €350. We confirm the exact price for your engine before starting.
Is Stage 1 safe for the engine?+
Yes. Stage 1 is an optimization within factory safety margins. The remap is done via the OBD2 diagnostic port without opening the ECU. Results are verified on our dynamometer.
How long does it take?+
Usually 2 to 4 hours, including diagnostics, remapping, and a dyno verification run.
Can the original software be restored?+
Yes, we keep a backup of your original ECU file. Reverting to stock is possible at any time.
Book Stage 1
Leave a request – we will contact you
By clicking, you agree to the processing of personal data